Manual Mode - GYS MONOGYS 160-2S Manual De Instrucciones

«MANUAL» MODE
To set your device, proceed as follow:
- Choose the welding voltage using the voltage selector
 Example for the Monogys 185-2S: position 1 for 0.6mm metal sheets and position 4 for 3 mm metal
sheets.
- Adjust the wire speed with the potentiometer
 Advice
The wire speed adjustment is often determinated by the «noise »: the arc must be stable and emit low
crackling.
If the speed is too low, the arc will not be continuous
If the speed is too high, the arc will crackle and the wire will push back the torch.
« SYNERGIC » MODE
This function automatically controls the wire speed. There is no need to set the wire speed manually.
Position the wire speed potentiometer
Select:
-

 Wire type
 Wire diameter
 Power mode (4 position switch)
To select the right position in accordance with the thickness of the workpiece, please refer to the
"synergic mode" table on the previous page.
From the combination, the Monogys 185-2S determines the optimal wire speed and the device is ready to
weld. It is also possible to adjust the wire speed if necessary by adjusting the potentiometer + or –
manually  .
The last welding configuration is saved in the memory automatically
 GAS (for steel welding) :
In synergic mode, the Monogys 160-2S, 185-2S and 200-2CS determine the welding settings in
accordance with the gas used. By default, in steel welding the machine is set to « Argon + CO2 ».
To change the gas and set the machine to C02 mode or go back to Argon + CO2 mode :
1- Press « Type » for 5 seconds until the panel switches off, then release.
2- After 5 seconds, choose the required setting using the « mode » button.
Normal (2T)  Argon + CO2 (default setting)
Delay  CO2 100%
3- Confirm selection by pressing the « Type » button, or waiting 5 seconds.
4- Once confirmed, the machine reverts to the normal operating mode but the gas mode chosen will stay
selected, even when the machine is switched off.
SPOOL GUN (OPTION ONLY FOR 185-2S AND 200-2CS; REF 041486)
DESCRIPTION AND FUNCTIONS OF THE SPOOL GUN TORCH
• The spool gun must be connected with the standard European connector and the command connector.
• The spool gun works in both « Manual » mode and « Synergic » mode.
• In « manual » and « Synergic » mode, only the wire speed adjuster on the torch

.

in the middle of the« Optimal synergic » zone.



 


is active
12