Quick Start - Alto Professional TSL115 Guia Del Usuario

Quick Start

Items not listed under
Example 1
MIX
METER PULSE
MOOD
PARTY
Example 2
Connect the left and right output of your DJ mixer, controller, etc. to Input 1 of each
loudspeaker using XLR or 1/4" (6.35 mm) TRS cables.
Tip: To send the same mix to both TSL115 loudspeakers, connect both channels of your DJ
mixer, controller, etc. to the Input 1 and Input 2 of one loudspeaker, and then connect that
loudspeaker's Mix Out to the Input 1 of the other loudspeaker. Both TSL115 loudspeakers will
then play identical summed mono mixes.
MIX
METER PULSE
MOOD PARTY
4
Introduction > Box Contents
Connect a dynamic microphone to the Input 1 using an
XLR or 1/4" (6.35 mm) TRS cable. Connect a guitar with an
active pickup to the Input 2 using a 1/4" (6.35 mm) TS
cable.
Note: When using the TSL115 loudspeaker with a guitar,
we recommend using one with active pickups rather than
passive pickups. If you use a guitar with passive pickups,
connect it to an external preamp or direct input (DI) box,
and connect the line-level output to the loudspeaker.
Also, we recommend using dynamic microphones with the
TSL115 loudspeaker rather than condenser microphones. If
you use a microphone that requires +48V of phantom
power, we recommend connecting it to an external phantom
power supply before connecting it to the loudspeaker.
MIX
METER PULSE
MOOD PARTY
are sold separately.