Binks MX432 Serie Manual De Instrucciones página 2

In this part sheet, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows:
WARNiNG
!
Hazards or unsafe practices which could
result in severe personal injury, death or
substantial property damage.
READ THE MANUAL
Before operating finishing equipment, read and
understand all safety, operation and maintenance
information provided in the operation manual.
WEAR SAFETY GLASSES
Failure to wear safety glasses with side shields
could result in serious eye injury or blindness.
DE-ENERGIzE, DEPRESSURIzE, DISCONNECT
AND LOCK OUT ALL POWER SOURCES DURING
MAINTENANCE
Failure to De-energize, disconnect and lock out
all power supplies before performing equipment
maintenance could cause serious injury or death.
OPERATOR TRAINING
All personnel must be trained before operating
finishing equipment.
EQUIPMENT MISUSE HAzARD
Equipment misuse can cause the equip ment to
rupture, malfunction, or start unexpectedly and
result in serious injury.
KEEP EQUIPMENT GUARDS IN PLACE
Do not operate the equipment if the safety
devices have been removed.
PROjECTILE HAzARD
You may be injured by venting liquids or gases
that are released under pressure, or flying debris.
PINCH POINT HAzARD
Moving parts can crush and cut. Pinch points are
basically any areas where there are moving parts.
PACEMAKER WARNING
You are in the presence of magnetic fields which
may interfere with the operation of certain
pacemakers.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION
FOR FURTHER SAFETY INFORMATION REGARDING BINKS AND DEVILBISS EQUIPMENT,
SEE THE GENERAL EQUIPMENT SAFETY BOOKLET (77-5300).
2
CAuTiON
!
Hazards or unsafe practices which could
result in minor personal injury, product
or property damage.
Warning
!
Read the following warnings before using this equipment.
TO THE OPERATOR OF THE EQUIPMENT.
Important installation, operation or
maintenance information.
AUTOMATIC EQUIPMENT
Automatic equipment may start suddenly without
warning.
INSPECT THE EQUIPMENT DAILY
Inspect the equipment for worn or broken parts
on a daily basis. Do not operate the equipment
if you are uncertain about its condition.
NEVER MODIFY THE EQUIPMENT
Do not modify the equipment unless the
manufacturer provides written approval.
KNOW WHERE AND HOW TO SHUT OFF THE
EQUIPMENT IN CASE OF AN EMERGENCY
PRESSURE RELIEF PROCEDURE
Always follow the pressure relief procedure in the
equipment instruction manual.
NOISE LEVELS
The A-Weighted sound level of pumping
equipment and spray guns may exceed 85 dB (A)
depending on the set-up being used. Details of
actual noise levels are available on request. It is
recommended that ear protection is worn at all
times when spraying while pump is operating.
HIGH PRESSURE CONSIDERATION
High pressure can cause serious injury. Relieve all
pressure before servicing. Spray from the spray
gun, hose leaks, or ruptured components can
inject fluid into your body and cause extremely
serious injury.
STATIC CHARGE
Fluid may develop a static charge that must be
dissipated through proper grounding of the
equipment, objects to be sprayed and all other
electrically conductive objects in the dispensing
area. Improper grounding or sparks can cause a
hazardous condition and result in fire, explosion
or electric shock and other serious injury.
PROP 65 WARNING
CA PROP
65 WARNING: This product contains chemicals known
to the State of California to cause cancer and
birth defects or other reproductive harm.
NOTE