Inserting/Replacing The Batteries - Bosch WEU Quigo Manual Original

OBJ_BUCH-2562-002.book Page 24 Monday, December 14, 2015 2:32 PM
24 | English
Cross-line Laser
Operating time, approx.
Weight according to EPTA-Procedure 01:2014
– Cross-line Laser
– Holder
Dimensions (length x width x height)
1) The working range can be decreased by unfavourable environmental conditions (e.g. direct
sun irradiation).
The measuring tool can be clearly identified with the serial number 9 on the type plate.
Assembly

Inserting/Replacing the Batteries

Alkali-manganese batteries are recommended for the measuring tool.
To open the battery lid 7, press the latch 10 in the direction of the arrow and re-
move the battery lid. Insert the batteries provided. Pay attention to the correct
polarity of the batteries according to the representation in the battery compart-
ment.
If the batteries become weak, the laser lines will flash quickly for a few seconds.
Always replace all batteries at the same time. Only use batteries from one brand
and with the identical capacity.
 Remove the batteries from the measuring tool when not using it for
extended periods. When storing for extended periods, the batteries can
corrode and self-discharge.
1 609 92A 1EC | (14.12.15)
Quigo
>5 h
0.27 kg
0.20 kg
65 x 65 x 65 mm
Bosch Power Tools