Axis M11 Serie Guia De Instalacion página 11

AXIS M11 Series
Adjust image and focus
To focus AXIS M1103/M1104:
Unscrew the focus puller on the lens. Adjust the
focus as required. Re-tighten the focus puller.
To focus AXIS M1113/M1114:
Click the Setup link at the top, right in the
1.
camera's web interface and go to Basic Setup
> Focus.
In the Focus Adjustment page set the DC-Iris to Disabled and click
2.
Save.
3. Unscrew the zoom puller on the lens by turning it anti-clockwise.
Adjust the zoom setting as required. Re-tighten the zoom puller.
4. Unscrew the focus puller on the lens. Adjust the focus as required.
Re-tighten the focus puller.
From the Focus Adjustment page, set the DC-Iris to Enabled and
5.
click Save.
Note:
• The DC-Iris should always be
disabled while focusing the
camera. This opens the iris to its
maximum, which gives the
smallest depth of field and thus
the best conditions for correct
focusing. When the focus is set
with this method it will then be
maintained in all light conditions
• The design of AXIS M11 Series
allows for slight lens movement to
ensure sensor alignment.
Lens
Focus puller Zoom puller
Page 11
r
Focus pulle