Resetting To The Factory Default Settings; Accessing The Camera From The Internet; Further Information - Axis M11 Serie Guia De Instalacion

AXIS M11 Series

Resetting to the Factory Default Settings

To reset all parameters and the IP address to Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed for about 15 seconds until the
Status indicator flashes amber. Release the Control button.
4. When the Status indicator displays green (which can take up to 1
minute) the process is complete and the camera has been reset.
5. Re-assign the IP address.

Accessing the camera from the Internet

Once installed, your AXIS M11 Series network camera is accessible on
your local network (LAN). To access the camera from the Internet,
configure network routers to allow incoming traffic, which is usually
done on a specific port:
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further
instructions. For more information on this and other topics, visit the Axis
Support Web at www.axis.com/techsup

Further information

The user's manual is available from the Axis web site at www.axis.com or
from the Axis Network Video Product CD supplied with this product.
Visit www.axis.com/techsup to check if there is updated firmware
available for the AXIS M11 Series. To see the currently installed firmware
version, see Setup > About in the camera's web pages.
Page 13