During Operation - GreenWorks Commercial GB 600 El Manual Del Propietario

BATTERy & CHARGER MAINTENANCE
End of charge
The charger switches itself off automatically when the battery is fully charged:
• Light emitting diodes on the battery turns off.
• The light emitting diode on the charger is solid Green.
• The charger's fan is switched off.
Remove the adapter from the charger.
BaTTERy LEDs
The LEDs show the battery's capacity & any problem with the battery or the power tool being
used.
Press button (1) to activate the LEDs – the display goes off automatically after 5 seconds.
The acoustic signal must sound briefly when the button is pressed (to confirm function) – see
also "Acoustic Signal".
During charging Process
The words showing the current battery capacity will begin to blink.

During Operation

LED will indicate the battery capacity.
If the LEDs glow continuously / flash
When there is an issue, the pack will show different fault codes – see "Troubleshooting".
E0 – BMS fault
E1 – Over-current (discharging)/(charging)
E2 – Communication fault (with charger or external tools)
E3 – Over-voltage of cell
E4 – Low-voltage of cell
E5 – Bad consistency of cell
E6 – External tools abstract electricity
HI – Over temperature of battery
Lo – Low temperature of battery
1
20