Style selections 70106 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1a. For outside mounting, clip mounting brackets (AA) onto
headrail of blind. Hold blind (C) level at the height
desired and center it over the window opening. Mark
the exact location of each mounting bracket (AA) with a
pencil. Remove the mounting brackets (AA) from the
headrail of blind (C). Predrill the screw holes and then
secure the mounting bracket (AA) to the wall or window
molding with mounting screws (FF).
Hardware Used
AA Mounting Bracket
Mounting Screw
FF
1b. For inside mounting, clip the mounting brackets (AA)
onto the headrail of blind (C). Hold the blind (C) in
place and make a pencil mark at the rear of each
mounting bracket (AA). Remove the mounting brackets
(AA) from the headrail of blind (C). Predrill the screw
holes and then secure the mounting bracket (AA) to
the wall or window molding with mounting screws (FF).
Hardware Used
AA Mounting Bracket
FF Mounting Screw
2. If necessary, use mounting screws (FF) to screw the
center support bracket(s) (GG) between the mounting
brackets (AA), from the side or from the bottom
depending on which mounting method you chose.
Hardware Used
FF Mounting Screw
GG Center Support Bracket
1a
FF
x 2
x 4
1b
x 2
x 8
2
x 3
x 1
4
AA
AA
FF
GG
FF