Troubleshooting - Moulinex dualio Manual Del Usuario

CLEANING THE ROLLER
WARNING
Turn off and unplug vacuum cleaner before performing maintenance to the vacuum cleaner.
1 •
Using a penny or small
coin, turn the roller re-
lease screw counter-
clockwise.
4 •
Place the roller back into
the slots

TROUBLESHOOTING

Review this table to find do-it-yourself solutions for minor performance problems. Any
other service needed should be performed by a qualified service dealer.
WARNING
Always turn off and unplug vacuum cleaner before performing maintenance to the vacuum
cleaner. Failure to do so could result in electrical shock or personal injury.
PROBLEM
Vacuum cleaner won't start
If the brush does not start
Poor job of dirt pick up
2 •
Lift and remove the roller
release latch.
5 •
Place the roller release
latch back into the
proper position
POSSIBLE CAUSE
1. Battery needs charging
2. Tripped circuit breaker/blown
fuse at household service panel.
The brush is blocked
1. Full or clogged dust bin.
2. Clogged airflow passages.
3. Dirty filters
20
3 •
Pull the roller out by
pulling up on the right
side – Clean the roller
6 •
Lock by turning the
roller release screw
clockwise with a penny
or small coin.
POSSIBLE SOLUTION
1. Plug in firmly, allow vacuum to
charge
2. Contact After Sale Service.
Clean the brush and wait for
about 10 minutes before
restarting.
1. Empty dust bin. (page 19)
2. Clear airflow passages.
(page 19 & 20)
3. Change/Clean filters. (page 19)