Control Panel Description - Toparc EVO 2.1 RE Manual Del Usuario

IBS ARMOTECH
The internal structure is made of reinforced steel anodised aluminium 6061 alloy to ensure durability
over time, despite continuous exposure to fumes.
Lightweight rigid aluminium pipe.
The square design of the extractor hood gives maximum extraction. The extraction flow is adjustable,
features an anti-intrusion grill and the hood has a handle for manoeuvrability.
EXTERNAL REJECTION
Gases and fumes generated during welding are rejected outdoors to prevent their spread into the workplace.
Provide a 150 mm diameter sheath to evacuate the smoke outside.

CONTROL PANEL DESCRIPTION

The machine features a control panel that also serves as the electrical engine protection hood.
The control panel is positioned on the front of the machine near the handle. The control panel is covered by a painted
casing and a control panel sticker depicted below.
In this position, the operator may use the control panel switch the machine on and off and operate the machine's various
functions.
The handle also protects the machine's control panel against accidental damage.
The control panel allows the operator to use and check machine operations.
USE OF THE EXTRACTING ARM
The machine is supplied with an extraction arm that must be assembled separately. The extracting arm must be atta-
ched on the purifier's perforated plate.
The extracting arm rotates 360° and can be used in large areas.
Opening or closing the arm must only be done while facing the machine.
Using the arm outside of the recommended range may cause the machine to tilt or fall.
Max 30°
Max 30°
FUME EXTRACTOR EVO 2.1 RE (230V)
+ ARM 160/3
EN
9