Axxess ASWC-1 Manual De Instalación página 9

Section 2: Programming
2) Turn the ignition on; the LED will start flashing red rapidly which means
the ASWC-1 is looking for the vehicle and the radio. Go to step 4.
If the ASWC-1 was installed in a vehicle previously:
2) Turn the ignition on, the LED will flash once, then go out.
3) Hold down the reset button for 3 seconds and then release it.
4) Perform action required for your particular vehicle as noted in the
vehicle info sheet.
5) After a couple of seconds the LED should stop flashing and not light
up for 2 seconds. At this point do not push any buttons.
6) After the 2 seconds there will be a series of 7 Green flashes, some
short and some long.
7) The LED will pause for another 2 seconds then flash Red up to 11
times (refer to ASWC-1 ledgend).
8) This is the end of the auto detection stage. If the ASWC-1 detected
the vehicle and the radio successfully the LED will light up solid.
9) For vehicles with OE Bluetooth buttons please press "Hang up"
or "Pick up" on your steering wheel control after the LED on the
ASWC-1 goes solid. If the OE Bluetooth buttons are able to be used,
the LED will go out after 3 seconds. Your OE Bluetooth buttons are
now programmed to your aftermarket radios Bluetooth buttons
(aftermarket radio must have Bluetooth capabilities).
Tip: If the LED does not light up solid refer to the
troubleshooting section.
10) Make sure the steering wheel control buttons function correctly in
the vehicle and enjoy.
--- Or ---
9