Unpacking And Inspection - VVG RivSmart Instrucciones Originales De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FUNCTION SYMBOLS
Sound warning ON
Sound Poke-Yoke ON
Sound keys + warning ON
Automatic reversing
Service ON
Clamping jaws service ON
COMMISSIONING

UNPACKING AND INSPECTION

The RivSmart (P) is delivered either in a card-
board box or in the L-Boxx. In both cases there is a
plastic inlay in the cardboard box or in the L-Boxx
to hold the various parts. Please check the scope
of delivery
• L-Boxx or optionally cardboard box
• Plastic inlay
• Riveter (P) with 4.0 mm mouthpiece (A) pre-in-
stalled
• Micro SD card (R) installed in the riveter
• Stud collector (short) (E)
• Mouthpiece box with mouthpieces 2.4 and
3.0/3.2 and 4.8/5.0 mm (A)
• Belt clip (O) with screw and rivet application
plate with screw (N)
• Stud securing cap (J) (blind screw connection)
for riveting without stud collector (E)
• One or two 12 V batteries (F), depending on
scope of order
• Charger
• Connecting cable with IEC power connector for
the charger
Sound keys ON
Sound keys + warning + Poke-Yoke ON
Manual reversing
DMSD (Lite) ON
Sound warning + Poke-Yoke ON
Automatic light 10 sec
P/Y auto trip
Stud monitoring ON
CHARGER / CHARGING BATTERIES
The battery (F) is partially charged on
delivery. In order to ensure the full
performance of the battery (F), charge
the battery (F) completely in the charger
before the first use. Observe the notes on the state
of charge on the charger. The Li ion battery (F) can
be recharged at any time without shortening its
service life. Interruption of the charging cycle does
not damage the battery (F). Connect the charger to
a plug socket using the cable supplied. Push the
battery (F) carefully and without force into the
holder. Remove the battery (F) in the same way.
The universal quick charger charges all Rivdom
PLUS batteries (F) with the voltages 12 / 16 / 20 V
in 30 minutes; the batteries are 90 % charged after
approx. 22 minutes. Observe the corresponding
indicators on your charger. The cells used for the Li
ion batteries (F) of the Rivdom riveters are high
quality and state-of-the-art. The optimum charging
and discharging temperature for the Li ion cells is
25 °C.
• Use only the connecting cable with IEC power
connector supplied. Different national versions
are available.
Sound keys + Poke-Yoke ON
Torch light 180 sec
P/Y manual trip
Counter ON
Job (Lite) ON
English | 35

Publicidad

Tabla de contenido
loading

Tabla de contenido