Warning Messages - VVG RivSmart Instrucciones Originales De Uso

WARNING MESSAGES

On the RivSmart the force, stroke, stud collector
and job are monitored by means of various sensors
and counters. Error messages or activities are
always displayed in red and the trigger is deactivat-
42 | English
The riveter can be calibrated under "Calibration".
Ensure that there is no rivet in the mouthpiece
and no rivet stud in the clamping jaws. During
calibration, the RivSmart performs a dummy stroke
(riveting process without rivet) to rule out faults
caused e.g. by wear or different ambient condi-
tions, and can detect exactly whether a riveting
stroke or dummy stroke was performed. Accuracy
is thus increased and faults are prevented. We re-
commend that this calibration is performed at least
once a day when using the DMSD Lite version,
depending on the intensity of use and changes in
the ambient conditions.
Confirm your selection with the "OK key" (T) or
quit the setup menu by holding the "OK key" (T)
depressed (>2 s).
ed. The error has to be acknowledged by pressing
the "OK key" (T) before the trigger (I) is activated
again.
This message is displayed when a job has been
completed, i.e. the required number of rivets have
been set correctly.
The "OK key" (T) has to be pressed before the next
job can be started.
The job settings can be made in the app.
Various job statistics are also displayed via the
app.