Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
■
Terminate the unused inputs with 75Ω loads
■
Connect the power supply unit and then connect the amplifier to the mains plug
Programming via display
The display will go out after 3 minutes if inactive, but the menu will remain open on the last
selected function. Press any key to resume to continue.
Function
selector
Password protection
Automatic channel research and memorization
AUTO-SCAN
The AUTO-SCAN function will scan the UHF band in input 1 and the BIII band in input 2.
The remote power is preset to OFF. It can be changed to ON in the INPUT V/U 1 and INPUT
V/U 2 menu. The remote power voltage is preset to 24V in the ADVANCED menu. The AUTO-
SCAN threshold is preset to 50dBµV in the ADVANCED menu. The LTE filter is preset to 5G
LTE700 in the ADVANCED menu.
1. Press
to activate the display
2. Press
for three seconds to enter the programming
menu
Pointer to scroll
figures
When a password has been set, the password must be
entered before accessing the programming menu. To enter
the password press the keys
each password number.
To start the automatic programming, AUTO-SCAN, place
the pointer
below AUTO. Press
amplifier will start scanning the channels of the UHF band
on input [1] and the III band on input [2].
To stop the AUTO-SCAN procedure press
- 14 -
Keys for browsing
the menu
Key to confirm
▲▼
then press
to confirm
to proceed. The
for 5 seconds.
Publicidad
Tabla de contenido
