Storage; Before Use; Charging The Battery - JSP PowerCap Infinity Instrucciones Para El Usuario

STORAGE:

• Store in the carry case provided.
• Store away from direct sunlight.
• Avoid contact with solvents and solvent atmospheres.
• Avoid physical contact with abrasive or hard surfaces.
• Store at temperatures between +5°C and +40°C.
• Store at relative humidity not greater than 75%.
• Disconnect the cable from the battery pack during storage.
• Do not stack objects on top of carry-case.

BEFORE USE:

• Fully charge batteries for 8 hours before first use. (See Charging the Battery).
• Check charge level by pressing the power button momentarily. (See Battery and Airflow Check).
• Read the adjacent LED charge level indicator. (See Battery and Airflow Check).

CHARGING THE BATTERY:

1. Remove the battery pack. Unplug the power cable from the socket, release the clasp at the base of the battery pack and pull the bottom
of the battery pack away from the helmet.
2. Attach the correct plug adaptor for your region to the 6v 2.5A power supply. Only ever use the power supply provided with this unit.
3. Plug the power supply cable into the rear of the PowerCap
switch on. (The dock LED will glow green).
4. Charge the battery pack. Insert the battery pack into the charging dock until it clicks (the dock LED turns from green to red.) The battery
is now charging. Once charging is complete, the dock LED will glow green.
5. To remove, hold the dock down and pull the battery upwards.
6. Replace the battery pack. Hook the top of the battery pack into the top of the helmet clip, rotate the battery pack fully into the helmet clip
and lock in place with the bottom clasp. Plug the power cable into the socket. The battery has an expected life of 500 cycles when charged
in accordance with these instructions.
1
4
Infinity charging dock. Plug the power supply into the mains socket and
® ®
2
5
5
3
6