Battery Replacement; How To Connect The Cables; How To Place The Electrodes - Globus DUO Pro Manual De Utilización

Battery replacement

Shut off the stimulator. Remove the battery cover by sliding it downwards and take out the batteries. Placed 3 alkaline
batteries of 1,5V AAA type LR03 and close the cover. Make sure that the new batteries are correctly placed with
respect to the polarity (note marks for + and-)
Electrode and battery removal
Don't throw the batteries or electrodes out but recycle or get rid of them appropriately following the removal rules in
force in your country.

How to connect the cables

It is possible to use one or two cables depending on use of one or two channels.
Connect the cable connector to the relative output placed on the inferior part of the unit. The outputs are exactly
below the correspondent channel (left or right).

How to place the electrodes

Remove the electrodes from the original wrapping and connect the cable plugs to them. Place the electrodes on the
skin following the images present in this manual. At the end of the treatment put back the electrodes in their special
seat.
Note: The new electrodes have a hermetic wrapping, therefore check that they are new and supplied together with the
unit.
ATTENTION: Don't remove the electrodes when the unit is working.
It is forbidden the reproduction and the copy of this manual without written permission of producer REV. 10.10 Data di emissione 10_10_2010
26