Programming With The Easy Controller - Gewiss Chorus GW 90851 Manual Del Usuario

PROGRAMMING WITH THE EASY CONTROLLER

Program the actuator with the Easy controller (GW 90 837 / GW 90 838 / GW 90 840) or
with the Easy base unit (GW 90 831).
The device can be selected by proceeding as follows:
• by pressing one of local command buttons: the corresponding channel will be
highlighted in the channel list;
• directly from the list of channels.
Names of the functions
blinds pushbutton
blinds
Shutter edges
scene
priority control
Wind sensor
Rain sensor
The functions can be created after the device has been selected.
Refer to the Easy base unit documentation for further information on the programming
procedures the Easy base unit or Easy Controller documentation.
Handling of shutters or blinds using blinds pushbutton
Handling of shutters or blinds using blinds
Handling command for shutters or blinds with edges
Actuation and memorising of the scenes
Override actuation
Actuation with wind alarm
Actuation with rain alarm
21
E
N
G
L
I
S
H