Programming With The Easy Configurator - Gewiss Chorus GW 10 754 Manual De Instrucciones

PROGRAMMING WITH THE EASY CONFIGURATOR

Program the push-button panel module with the Easy controller (GW 90 837 / GW 90 838 / GW 90
840).
If this device is added as an expansion to a KNX system programmed with the Standard
Unit (GW 90 831), please contact the Gewiss SAT Technical Assistance Service.
The device channels can be selected as you require:
• channel 1 of the push-button panel: directly from the list of channels
• channels 2-6 of the push-button panel: pressing the relevant push-button for each
channel, or directly from the list of channels
• actuator channel: pressing the programming key for at least 2 seconds, directly from
the list of channels, or via channel 1 of the push-button panel (when the latter is not
associated with any function).
The functions can be created once the devices have been selected.
25
E
N
G
L
I
S
H