Product View; Cleaning Formulas - Bissell PROHEAT 2X LIFT-OFF Manual Del Usuario

A

Product View

Do not plug in your cleaner until you have
completely assembled it per the following
instructions and are familiar with all
instructions and operating procedures.
1 Spray Trigger
2 Upper Handle
3 Upright Cleaning Mode
Indicator Light
4 Carry Handle
5 Cleaning Tool (tools vary by
model)
6 Formula & Water Tank
7 Power Button
8 Quick Release™ Cable Wrap
9 Power Cable
10 Dirty Tank
11 Dirty Tank Carry Handle
12 Flex Hose
13 Portable Spot Cleaning
Release Pedal
14 EdgeSweep™ Brushes
15 Removeable Nozzle
Assembly
16 Cable Clip
17 Tool Storage
18 Support Handle
19 Tool Storage (select
models)
20 Hose Secure Latch
21 Recline Pedal
To reduce the risk of fire and electric shock
due to internal component damage, use only
BISSELL cleaning fluids intended for use with
the deep cleaner.
To reduce the risk of fire, use only BISSELL deep
cleaning formula for full size machines in your
deep cleaner. Use of cleaning formulas that
contain lemon or pine oil may damage this appliance and
void the guarantee. Chemical spot cleaners or solvent-based
soil removers should not be used. These products may react
with the plastic materials used in your deep cleaner causing
cracking or pitting.
Scotchgard™ is a trademark of 3M®.
Febreze and related trademarks are owned by The Procter & Gamble Company, Cincinnati, Ohio, and used under
license by BISSELL Homecare, Inc.
6
www.BISSELL.com
A-2 Cleaning
Formulas
Always use genuine
BISSELL deep

cleaning formulas.

Non-BISSELL cleaning
formulas may harm
the cleaner and may
void the guarantee.
22 1.5 L 2X Wash & Protect
PRO Professional Stain
& Odour Formula w/
Scotchgard™ Protector
23 1.5 L 2X Wash & Protect PET
Pet Stain & Odour Formula
w/ Scotchgard™Protector
24 1.5 L 2X Wash & Protect
Stain & Odour Formula
w/ Scotchgard™ Protector
25 1.5 L 2X* Wash &
Refresh Blossom & Breeze
w/ Febreze™ Freshness
*2X concentrated formula, 60
mL is equivalent to 120 mL of
non-concentrated formula
B
Assembly
There are two easy to assemble components:
A. Upper handle
B. Portable spot cleaner/Base
The only tool you will need to assemble
your cleaner is a long Phillips screwdriver.
1. Slide upper handle onto body of machine
by guiding 2 posts on body into opening on
upper handle.
2. Firmly holding upper handle in place,
screw 2 screws into marked holes at an
upward angle above support handle.
3. At an upward angle, screw remaining
2 screws into marked outermost holes under
support handle.
4. Wrap power cable around Quick Release
Cable Wrap.
5. Wrap flex hose around hose wrap and
secure with hose secure latch.
6. Align product as shown and firmly push
down portable spot cleaner until it is secured
on both sides.
To further check if portable spot cleaner is
secure, plug in and turn on to verify upright
cleaning mode indicator light is illuminated.
If it does not illuminate, release portable spot
cleaner and re-secure by pushing firmly until
both sides snap into place.
7. Check latches on both sides to confirm
it is secured. Refer to image 6.
8. Snap attachment(s) into back of unit.
NOTE: Portable spot cleaner must be fully
secure to operate in upright cleaning mode.