Wall Pad Operation - Salvador Escoda MUCSW-16-HG Manual De Instalación Y Funcionamiento

1) Clock display and setting
System has an accurate internal real time clock (RTC) used for time indication and timer ON/OFF function.
Normally, real time clock display area indicates internal time clock which can be set by
2) Day display and setting
The wall pad support day display function, it can be used as day indication and timer ON/OFF function, day
display icon indicates current day. Press
3) Timer ON/OFF setting
If master unit is in global control mode and on/off timer setting is reached, master unit will command the whole
network to be on or off. Otherwise timer on/off is effective to the local unit only. The system supports 7 days
on/off timer setting.
TI M ER
a) Press
day display area indicates the day for setting timer on. If on timer for this day is null, timer display area
shows
on timer setting. Press
shows
TI M ER
b) Press
The setting method is the same as on timer setting above.
TI M ER
c) Press
d) Should there be any on or off timer being programmed,
unexecuted on or off timer for the current day, its corresponding
e) Hold down
Timer set by master unit are as follow:-
1. Press
unit under control. Press
skipped automatically.
TI M ER
2. Press
the require day of week. Master unit will then retrieve the setting from the selected slave unit and
timer display area will show 'rEAd'. The on timer setting will be shown upon reading the data

WALL PAD OPERATION

button once,
, otherwise the on timer setting will be shown. Press
C AN C EL
key to cancel the current on timer selected and the timer display area
. Press button to change the day the on timer to be programmed.
and OFF symbol blinking indicates off timer programming mode.
button again,
button again, to exit timer on/off setting function.
C AN C EL
button for 3 sec will cancel all timer settings.
NET
button to enter into networking control mode. Unit area blinking indicates the slave
TI M E
button once to enter into on timer programming mode. Press
button to set day.
ON
and symbol blinking indicates on timer programming mode,
TI M E
or to select the desired slave unit. Units that offline will be
9
TI M E
or
TI M E
TI M E
or button to change the
will light up. Should there be any
ON
or OFF icon will light up.
TI M E
button.
button to select