( 5 )
Fridge
The Fridge button serves two purposes:
(Hold 3
- To set the Fridge to your desired
sec for
temperature.
Power
- To turn the Power Cool function on
Cool)
and off.
1) To set the Fridge temperature
Press the Fridge button to set the
refrigerator to the temperature you want.
You can set the temperature between
44°F (7°C) and 34°F (1°C) .
2) Power Cool function
Touch and hold this button for 3 seconds
to decrease the time needed to cool
products in the Refrigerator. It can be
helpful if you need to quickly cool easily
spoiled items or if the temperature in
the fridge has warmed dramatically (For
example, if the door was left open).
( 6 )
The Ice Off button serves two purposes:
Ice Off
- To turn the Ice maker on and off
(Hold 3
- To turn the Child Lock Function on
sec for
and off.
Child
1) Ice Off Function
Lock)
If you don't want to make more ice, press
the Ice Off button.
2) Child Lock Function
Touch and hold this button for 3 seconds
to lock the display, the Flex Zone panel,
and the dispenser buttons so the buttons
can not be used.
When the Child Lock is on, the refrigerator
does not dispense ice or water even if you
press the Dispenser Lever.
The child lock icon lights up to indicate
you've activated the child lock function.
Press 3 seconds to unlock.
(7)
Cubed Ice
(8)
Press the Cubed Ice or Crushed Ice
Crushed
button to select the type of ice you want
Ice
dispensed.
Each time you press the button, the
cubed and crushed ice modes alternate
and the Cubed or Crushed ice icon lights
(Cubed)
up, indicating your selection.
(Crushed)
( 9 )
If you don't want to make more ice, touch
Ice Off
the Ice Off button.
The icon will light up and the Ice-Maker
stops making ice.
We recommend you stop ice
making if the following occur:
- There is enough ice in the ice
bucket.
- You want to save water and
energy.
- Water is not being supplied to
the refrigerator.
If the ice maker function is ON, and
the water line is not connected,
there will be a water valve noise
from the back of the unit. If this
occurs, press the Ice Off (Hold
3sec for child lock) button for less
than 3 seconds until the Ice Off
Indicator (
To save electricity, the Panel Display turns off
automatically under the following conditions:
When no button has been pressed, when no
doors are open, or when no Dispenser Lever
has been pushed. However, the icon indicating
your cubed or crushed ice selection will stay
on. When you press a button, open a door, or
push a Dispenser Lever, the Panel Display will
turn on again. All function keys, except Energy
Saver and the Cubed and Crushed keys will
become operational after you remove your
fi nger from the button you pressed.
( 10 )
Water filter usage
Filter
This icon lights up when you need
to change the filter, usually after the
refrigerator has dispensed about 300
gallons of water (after about 6 months).
After you install the new water filter, reset
the filter indicator by touching and holding
the Hold 3sec for Filter Reset button for
3 seconds.
- If water is not dispensing or
dispensing slowly, you need to
replace the water filter because
the water filter is clogged.
- Some areas have large amounts
of lime in their water, which
causes the water filter to clog
more quickly.
) illuminates.
operating _25