Rear Panel - Rohde & Schwarz R&S ZN-Z15 Manual Del Usuario

®
R&S ZN-Z15
2.1.2

Rear Panel

This section shows all interfaces on the back of the R&S ZN-Z15.
5
Figure 2-2: R&S ZN-Z15 Rear Panel
Table 2-1: Rear panel elements
Index Label
1 12 V DC
IN
2 LEDs
3 DIRECT
CTRL
4 DIRECT
CTRL
5 LAN
6 USB
7
TRIG
1, 2
See the R&S ZN-Z15 Data Sheet for interface specification details.
User Manual 1177.5479.02 ─ 02
6
3
Description
Connector for the +12V/1A external DC power supply
DC power supply status
●
Green and orange LED on: 12 V external power supply voltage
●
Only orange LED on: insufficient input voltage at external power supply
DIG-IQ connectors: Direct Control (Prog Bus) interface, incoming (from
R&S ZNB/ZNBT) and outgoing (to other Direct Control devices); see
ter 2.3.2, "Direct Control",
RJ-45 connector to integrate the instrument to a Local Area Network, pri-
marily for remote control purposes; see
Type B (slave) high speed USB connector, for remote control; see
ter 2.3.3, "USB", on page 14
BNC connectors for incoming 5 V TTL external signals whose falling edges
can trigger RFFE command execution and/or GPIO voltage changes
(sweep sequencer mode)
Putting the Instrument into Operation
7
4
on page 13
Chapter 2.3.4,
Instrument Tour
1
2
"LAN", on page 14
Chap-
Chap-
9