Replace The Filter Bag; Replace The Filter Package; Replace Dust Bags; Clean The Float Ball - Nederman ATEX Serie Manual De Instrucciones

6.4

Replace the filter bag

NOTE! If the filter bag is placed into a dust bag for disposal, tie off the dust bag, see
figure 8.
1. Turn off vacuum cleaner.
2. Empty pre-separator, if one is used.
3. Remove filter basket and filter bag.
4. Replace filter bag.
6.5

Replace the filter package

NOTE!
• If the filter package is placed into a dust bag for disposal, tie off the dust bag, see
figure 8.
See figure 11. The particles collect on the outside of the filter. Cleaning is carried out every
other hour or when the vacuum performance decreases. Replacing the entire filter package
is recommended. When only changing the socks, the filter ring should also be replaced.
6.6

Replace dust bags

WARNING! Risk of personal injury (A EX 2GD & 3GD).
• Always use
• Connect the upper and lower ground wires to the bag.
Replace dust bags when they are filled. How often this occurs varies for each installation.
Regular checks are recommended.
Replace dust bags as follows:
1. Turn vacuum cleaner off.
2. Remove (and close) bag opening from bag holder. Pay special attention to avoid
unnecessary spillage/leakage of dust and accidental discharge of static electricity.
3. For bulk-bags:
1) Remove the two earth clamps from the earth tags on the bag.
2) Tie off and replace bulk-bag, see figure 7.
3) Refit the two earth clamps onto the earth tags.
4. Attach the bag opening to the bag holder. For bulk-bags, see figure 7.
5. Turn on vacuum cleaner.
6.7

Clean the float ball

NOTE! To put back the float ball after cleaning, see figure 10.
If the vacuum cleaner is used for wet material, clean the float ball once a month.
approved bulk bags.
A EX 2GD - Vacuum Cleaners EN
25