Installation Instructions - GE SPACEMAKER DSXH47 Manual Del Usuario

Installation
Instructions
If you have any questions, call 800.GE.CARES (800.432.2737)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time – 1–3 hours
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Remove and discard existing plastic or metal foil
duct and replace with UL-listed duct.
IN THE COMMONWEALTH OF
MASSACHUSETTS
• This product must be installed by a licensed
plumber or gas fitter.
When using ball-type gas shut-off valves, they
•
shall be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 feet.
CALIFORNIA SAFE DRINKING WATER
AND TOXIC ENFORCEMENT ACT
This act requires the governor of California to publish
a list of substances known to the state to cause cancer,
birth defects or other reproductive harm and requires
businesses to warn customers of potential exposure to
such substances. Gas appliances can cause minor
exposure to four of these substances, namely benzene,
carbon monoxide, formaldehyde and soot, caused
primarily by the incomplete combustion of natural
gas or LP fuels. Properly adjusted dryers will minimize
incomplete combustion. Exposure to these substances
can be minimized further by properly venting the dryer
to the outdoors.
Save these
Observe all
Be sure to leave these
Keep these instructions
Spacemaker Dryer
or visit our Website at:
FOR YOUR SAFETY:
WARNING
• To reduce the risk of severe injury or death, follow all

installation instructions.

• Clothes dryer installation must be performed by a
qualified installer.
• Install the clothes dryer according to these instructions
and in accordance with local codes.
• This dryer must be exhausted to the outdoors.
• Use only 4" (10 cm) rigid metal ducting for exhausting
the clothes dryer to the outdoors.
• DO NOT install a clothes dryer with flexible plastic
ducting materials. If flexible metal (semi-rigid or
foil-type) duct is installed, it must be UL-listed and
installed in accordance with the instructions found in
"Connecting the Dryer to House Vent" on page 12 of
this manual. Flexible ducting materials are known to
collapse, be easily crushed, and trap lint. These
conditions will obstruct dryer airflow and increase the
risk of fire.
• Do not install or store this appliance in any location
where it could be exposed to water and or weather.
• Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
• The National Fuel Gas code restricts installations of
gas appliances in garages. They must be 18" (45.7 cm)
off the ground and protected from vehicles by a
barrier. See Location of Your Dryer section.
• The electrical service to the dryer must conform with
local codes and ordinances and the latest edition of the
National Electrical Code, ANSI/NFPA 70 or in Canada,
CSA C22.1 Canadian Electrical Code Part 1.
• The gas service to the dryer must conform with local
codes and ordinances or the latest edition of the
National Fuel Gas Code ANSI Z223.1 or in Canada,
CAN/CGA B149.12. The gas dryer is designed under
ANSI Z 21.5.1 or ANSI/UL2158–CAN/CSA C22.2
(latest editions) for home use only. This dryer is not
recommended for commercial applications such as
restaurants or beauty salons.
9
Model DSXH47
GEAppliances.com