SICK UE 4215 Manual Del Usuario página 112

Chapter
" ##
112
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
" ##
This chapter describes the preparation and completion of the installa-
tion of the safe busnode UE 4215. The installation and mounting re-
quires the following steps:
Selection of a suitable assembly location (cf. chapter 4.1
"Selecting the assembly location")
Mounting on a base with functional earthing (cf. chapter 9.2
"Accessories"), if the ESPE connected requires functional earthing
* # $
The safe busnode UE 4215 is a decentral component. Select a
suitable assembly location on the basis of the following criteria:
Mounting position in the immediate vicinity of the hazardous point
to be protected
Short cable paths to the components to be connected
Flat assembly surface to enable the housing to be assembled
without becoming distorted
Diagnostic LEDs of the device visible, simple device exchange
Protected in order to prevent any removal or breakage of the
connecting wires by personnel or the device
Sufficient space for the plug connections
With respect to vibrational and impact load, temperature and
humidity, suitable in accordance with the data in chapter 8
"Technical specifications".
$
$
# #
Operating Instructions
8 010 654/O571/19-08-04