Logger Function - Promax PROLITE-63 Manual Del Usario

USER'S MANUAL PROLITE-63
[3] Lower value threshold.
[4] Name assigned to the group of threshold values.
To modify the threshold values:
1.- Press SEL
2.- To change a parameter, it must be shaded. Once it is shaded it can be
modified by using the arrows.
3.- Once changes are made, press again SEL
parameter.
4.- To get out from the configuration mode and back to the main menu press
CONFIG

4.2.5 LOGGER Function

LOGGER function takes data and save them on the memory, so they can be
viewed or downloaded on a computer
Each funtion has its own logger memory up to 99 loggers par function.
To access the LOGGER Function:
1.- From the function you are press STO / RCL
2.- Upper line on the screen changes (see figure below).
In this line is shown the last logger accessed and date and hour when was
taken.
3.- If the upper line does not show date and hour means that the register is
empty (see figure below).
06-2011
[4] to move along the parameters.
[2].
Figure 7.- Logger.
Figure 8.- Empty Register.
[4] to get out from editing the
[3].
Page 17