Automatic Signal Identification Function (Auto Id) - Promax US TV EXPLORER II Manual De Uso

USER'S MANUAL. US TV EXPLORER
In order to select the supply voltage of the external units, press
the screen will display a functions menu labeled EXT. SUPPLY listing the choice of
voltages (which will depend on the band being used). Turn the rotary selector
the desired voltage and press to activate it. The following table shows the choice of
supply voltages:
Band
SATELLITE
TERRESTRIAL
MATV
(Master Antenna Television)
In the External power supply mode is the unit powering the amplifiers before the
antenna (terrestrial television) or the satellite TV receiver (house-hold or community)
also powers the external units.
The DRAIN [3] indicator lights when current is flowing to the external unit. If any
kind of problem occurs (e.g., a short circuit), an error message appears on the monitor
('SUPPLY SHORT'), the acoustic indicator will be heard and the instrument will cease
to supply power. The US TV EXPLORER
until the problem has been solved, during this time it verifies every three seconds the
persistence of the problem warning with an acoustic signal.
5.8

Automatic signal identification function (AUTO ID)

The US TV EXPLORER
to the established configuration, which are presents in the channel or tuned frequency.
In order to activate this function must once press
combine this process with the spectrum monitoring
marker on the levels susceptible to contain a transmission, and activating later the
process of automatic identification in order to identify the present signal.
11/2013
II
Powering voltages
External
5 V
13 V
15 V
18 V
24 V
13 V + 22 kHz
18 V + 22 kHz
External
5 V
13 V
15 V
18 V
24 V
Table 3.- External units powering voltages.
II does not return to its normal operating state
II allows automatically identifying TV signals, according
[11] key, and
[25] key. Specially useful, is to
[13], so that after locating the
[1] to
Page 31