Textron Greenlee H4802 Serie Manual De Instrucciones página 4

IMPORTANT SAFETY INFORMATION
• Do not change accessories, inspect, or clean
tool when it is connected to a power source.
Accidental start-up can result in serious injury.
• Maintain a firm grip on tool, using both hands at
all times. Serious injury can result if an operator
does not control the tool.
Failure to observe these warnings could result in
severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Wear foot protection when using
this tool.
Failure to observe this warning
could result in serious injury.
Wear hearing protection when using
this tool.
Long-term exposure to high noise
levels could result in hearing
damage.
Do not reverse hydraulic flow. Operation with
hydraulic flow reversed can cause tool malfunction.
Connect the supply (pressure) hose and return (tank)
hose to the proper tool ports.
Failure to observe this warning could result in severe
injury or death.
Greenlee / A Textron Company
H4802 Series Pole Tampers
Vibration hazard:
Apply just enough pressure to do the work. Applying
excess pressure to the tamper can cause operator
discomfort or temporary numbness.
• Inspect the hydraulic hoses and couplings every
operating day. Repair or replace if leakage, crack-
ing, wear, or damage is evident. Damaged hoses
or couplings can fail, resulting in injury or property
damage.
• Use this tool for manufacturer's intended use only.
Use other than that which is described in this
manual could result in injury or property damage.
• Make sure all bystanders are clear of the work
area when handling, starting, and operating the
tool. Nearby personnel can be injured by flying
parts in the event of a tool malfunction.
Hydraulic oil can cause skin irritation.
• Handle the tool and hoses with care to prevent
skin contact with hydraulic oil.
• In case of accidental skin contact with hydraulic
oil, wash the affected area immediately to remove
the oil.
Failure to observe these precautions may result
in injury.
Procedure for connecting or disconnecting hydraulic
hoses, fittings, or components:
1. Move the flow lever on the hydraulic power
source to the OFF position.
2. Stop the hydraulic power source.
3. Follow the sequence under "Hose Connections"
to prevent pressure buildup. In case some
pressure has built up, loosen hoses, fittings, or
components slowly.
Note: Keep all decals clean and legible, and replace
when necessary.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070