Hose Connections; Typical Setup - Textron Greenlee H4802 Serie Manual De Instrucciones

Hose Connections

Tool Port Identification
Three methods are used to identify the pressure and
return ports of Greenlee Utility tools. Match the mark-
ings on your tool to this table.
Pressure Port
P
In
9/16–18 O-ring Boss
(smaller port)

Typical Setup

Greenlee / A Textron Company
Return Port
T
or
Out
or
3/4–16 O-ring Boss
(larger port)
H4802 Series Pole Tampers
H4802-3 and H4802-5:
Connecting Hoses
1. Move the flow lever on the power source to the
OFF position.
2. Stop the hydraulic power source.
3. Connect the return hose to the return port on the
power source, then to the return port on the tool.
4. Connect the pressure hose to the pressure port
on the tool, then to the pressure port on the power
source.
Pressure
(Port P)
Disconnecting Hoses
1. Move the flow lever on the power source to the
OFF position.
2. Stop the hydraulic power source.
3. Disconnect the pressure hose from the power
source, then from the tool.
4. Disconnect the return hose from the tool, then from
the power source.
5. Install dust caps over the ports to prevent
contamination.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Return
(Port T)