MTD OHD-190-180 Manual Del Operador página 11

Retainer Strap
Grass Catcher Pin
Figure 24
Figure 25
Pocket
Tab
Figure 26
Attaching Discharge
Chute
All Model Series
1. Raise the deck to its highest position.
2. Raise the chute deflector on the deck and hold it
while you position the discharge chute over the
chute opening.
3. Place the top rear edge of the discharge chute over
the top rear edge of the chute opening.
4. Push down on the discharge chute so that its front
bottom edge rolls around the bottom of the deck,
then slide the chute forward to the stop on the deck.
See Figure 24.
5. Lock the discharge chute in position by hooking
the retainer strap over the grass catcher pin on the
deck. See Figure 24.
6. Insert the curved end of chute tube into the hole in
the grass bag cover. See Figure 25.
7. Place the lower end of the chute tube over the
discharge chute so that the tabs on the discharge
chute fits into the pockets on the chute tube. See
Figure 26.
8. Secure by hooking the two retainer straps of the
discharge chute to the pins on the chute tube. See
Figure 26.
Bagger Usage
All Models - 600 through 700
NOTE: When both grass bags are full, place the tractor
on a firm, level surface, disengage the PTO, turn the
tractor engine off and set the parking brake.
1. Flip Seat up.
2. Lift up grass bag cover. Do not remove the chute
tube assembly from the tractor.
3. Remove the grass bags by lifting these up and mov-
ing the bags away from the support tube assembly.
4. Empty the grass clippings at a proper disposal sight,
use the handle at the bottom of each grass bag.
Holding the bag firmly, empty the contents
5. Replace grass bags, close lid, flip down seat, restart
your tractor and resume cutting your grass.
11
5
Attaching
Discharge
Chute
All Model Series
NOTE:
When both grass bags
are full, place the tractor
on a firm, level surface,
disengage the PTO, turn
the tractor engine off and
set the parking brake.