Kreg KRS1035 Instrucciones De Ensamblaje página 3

Add the end rails
1 Lay one side assembly inside face up on your work surface.
Position the end rails (5), insert carriage bolts (3), and fi nger-tighten
the nuts (4). Square the end rails to the legs, and then tighten the nuts.
2 Position the second side assembly on the upright ends of the end
rails. Insert carriage bolts and tighten the nuts, again making sure
the rails are square to the legs.
Install the feet and the levelers
1 Place the legs/rails assembly upside down on your work surface.
Position a foot (6) inside each upended leg. Fasten each foot with
four carriage bolts (3) and four nuts (4).
Assembly
5
3
6
6