List Of Loose Parts; Installation - Craftsman 124.47747 Manual Del Operador

A

LIST OF LOOSE PARTS

A. Drill Press Head Assembly
B. Column Assembly
C. Base
D. Table Assembly
E. Feed Handles (3)
F. 1/2" Chuck
G. Chuck Key
H. Column Mounting Bolts (3)
I. 4mm Hex Wrench
J. Operator's Manual (not shown)
MOVING & INSTALLING THE DRILL PRESS
1. When moving the Drill Press, hold both the
column and under the drill press base to lift and
move the machine. CAUTION: The drill press
head with attached motor is top heavy and must
remain upright to avoid tipping.
2. Secure the machine onto a solid stand, or
bench, that is located in an area that has ample
space in front and at both sides for working and
moving work pieces around the drill press.
3. For best power and safety, the machine
should be plugged directly into a dedicated
grounded electrical outlet that is within the
CONTENTS OF PACKAGE

INSTALLATION

supplied cord length of the machine. The use of
an extension cord is not recommended.
4. Align the machine so that during use, any
projects, debris or kickback will not face aisles,
doorways, or other work areas that bystanders
may be in. Do not locate or use the machine in
damp or wet conditions.
5. Once in place in your shop, make sure that
the machine is level. Secure the machine to a
bench or stand, with lag screws or bolts (not
supplied). This will eliminate any tipping over of
the drill press, and reduce any possible vibration
during use.
8
B
C
E
F
G
D
I
H