Die Installation / Maintenance - Rhin-O-Tuff OD4012 Manual De Instrucciones

Providing power to the machine:
Power cord shall be certified for the country
u
where the machine will be installed. Plug one
end of the power cord into the power cord
receptacle on the back of the machine. The
other end goes into the wall outlet.
Die Installation:
Diagram 2.
u
off before installing the die
Make sure there is no paper dust or paper chips
u
in the machine die slot before installing the die.
Install the die by sliding it into the opening
u
located on the left hand side of the machine. Make sure the punch pin
retainer slides into the slot on the backside of the opening.
Install die until right side of die is flush to exterior of right side of
u
machine.
Thread both retained die lock knobs into the die and tighten evenly
u
until the die can not move.
Punch Pin
Retainer
Die Lock Knob
Make sure the machine is turned
Diagram 2. (Image of OD4012)
.
6
! DANGER
Hazardous voltage.
Use only approved
power cord
assemblies.
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.