English - XD P326.963 Manual De Instrucciones

ENGLISH

Instructions
The Floating Aqua speaker is compatible with most Bluetooth audio devices. Fully portable,
it is an ideal wireless communication solution for outdoor and water activity use within range
of 10meters.
Charging the speaker
Make sure that your Floating Aqua speaker is fully charged before using it.
A full charge is approximately 4 hours and plays continuously 8 hours.
1. Connect the speaker to the USB charging cable to charge.
2. When the LED indicator is RED, the speaker is charging
3. The LED indicator goes off when the device is fully charged.
NOTE: Do not charge the product while it's wet, please make sure that the product is dry
before charging in order to avoid the risk of electric shock.
Turning the Floating Aqua speaker on and off
1. Press once to turn the Floating Aqua speaker "ON". A string of tones appear and the BLUE
Indicator blinks.
2. Press again to turn the Floating Aqua speaker "OFF". A string tones appear and the BLUE
Indicator goes off.
3. When the battery is low, the speaker turns off automatically after hearing 3 tones. Please
charge your speaker immediately.
Pairing the Floating Aqua speaker with your device
1. Activate Bluetooth on the device.
2. Turn the Floating Aqua speaker on and switch to pairing mode by holding onto the Volume
Up (+) and Volume Down (-) buttons at the same time for 2 seconds till a string of tones is heard
when setting to pairing mode.
3. When you turn on your Floating Aqua speaker for the first time, the Bluetooth-enabled
phone will automatically start up in pairing mode.
(1) The blue indicator light blinks and a string of tones appear while pairing.
(2) Search for new devices on your phone.
(3) Choose "Floating Aqua Speaker" in the list of Bluetooth devices.
(4) Press "Yes" or "OK" on the phone and if necessary confirm with PIN code 0000 (4 zeros)
4. Your phone will confirm when the pairing is complete and a string of tones will appear to
tell you that the Floating Aqua speaker is connected.
3