Nice E FIT MHT 1517 Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

5.13 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
5.13.1 - Procedure performed with a transmitter memorised in "Mode I"
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory: Keep the s and t keys pressed and wait for the motor to perform five movements. Upon completion, release the keys.
• To delete all memorised transmitters: do not press any key and wait until the motor performs 5 movements.
• To delete a single memorised transmitter: hold down the s key and wait for the motor to perform 3 movements. Now release the key. Lastly, press the but-
ton of the transmitter you wish to delete: the motor performs 5 movements.
• To delete only the limit switch heights ("0", "1", "2", "S") and intermediate heights ("H"): WARNING: – This deletion must be performed only when
you want to adjust the limit switch heights again, using a different procedure than the one used previously. Keep the n key pressed and wait for the
motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
04
3
5
sec.
05
all
5
...
sec.
05
(*)
"0"
"1"
5
"H"
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.13.2 - Procedure performed with an unmemorised transmitter
To delete the memory with an unmemorized transmitter, proceed as follows:
01. Shut off power and wait for at least 2 seconds.
02. Restore power, and turn the emergency mechanism at least 6 full turns within 10 seconds.
03. You now have 1 minute of time to delete the memory (see procedure in par. 5.13.1) with any transmitter, even if it has not been memorized.
01
OFF
2
sec.
02
2
all
data
05
single
5
02
ON
X 6
I – –> max 10 sec. – –>I
3
5
sec.
05
5
5
sec.
3
5
sec.
03
01 02 03 04 05
Paragraph 5.13.1
I – – – –> max 60 sec. – – – –>I
03
3
5
sec.
key example
(transmitter 5
to be
deleted)
English – 10