Machine Details - Evolution TWISTER Manual De Instruccion

protection and resistance to the start-up and operating torque. Place the work
properly and hold the machine firmly WITH BOTH HANDS to prevent loss of
control which could cause personal injury. Protect your eyes from injury with
safety glasses or goggles.
WARNING:
Keep the cord behind the operator and away from mixing area to
prevent it from becoming entangled in the paddle.
Handles
The handles of the Electric Mixer are designed for an optimum grip.
Handles Placing Position
Please pay attention when placing the Electric Mixer on the ground. Please do
not let the Mixer rest on the power cable where it enters the handle. NOTE:
Incorrect placing of the Electric Mixer Machines will cause the electrical cord to
damage, increasing electrical shock risk and damage to the Machine.
1. Speed Control Wheel
2. Start Switch
Safe Disposal Instructions for the protection of the environment.
The machine contains recyclable materials. Take the discarded apparatus and
accessories to the relevant recycling facilities.
Component
Operator handle
Motor housing
Gearbox housing
Paddle
Various parts
Most motor troubles may be traced to loose or incorrect connections, overload,
or to over long supply circuit wire. Always check the connections, the load and
the supply circuit whenever motor doesn't work well. Check wire sizes and length
with the Cord Size Chart.
Wire Sizes
NOTE: Make sure the proper extension cord is used and is in good condition. Use only
3-wire extension cords that have 3-prong grounding plugs and 3-pole receptacles
that accept the tool's plug. The use of any extension cord will cause some loss of
power. To keep this to a minimum and to prevent overheating and motor burnout,
use the table below to determine the minimum wire size extension cord.

MACHINE DETAILS

ENVIRONMENT
TROUBLESHOOTING
3. Spindle
4. Mixing Paddle
Material
Plastic
Plastic
Aluminium
Steel
Steel, Copper & Plastic
5