Publicidad
Idiomas disponibles
Idiomas disponibles
Available Interfaces
Note
Cables are not supplied with your printer.
Your printer has three interfaces:
1
Ethernet
- For network cable connection of PCs and/or
Macs
- 10Base-T and 100Base-TX
2
USB
- For direct connection to a PC or Mac.
- Requires a cable conforming to USB version
2.0 or above.
3
Parallel (Windows only)
- For direct connection to a PC.
- Requires a bi-directional parallel cable
(compatible with IEEE-1284)
Installation Procedures
Windows
Network Installation, see below.
USB Installation, see page 15.
Parallel Port Installation, see page 15.
Macintosh
Network installation, see page 16.
USB Installation, see page 17.
Windows Network
Installation
Make the Network Connection
Important!
In order to reduce electromagnetic
interference—"noise" that interferes with
TVs or other appliances—you must install
the included ferrite core on the network
cable.
Note
The Ethernet cable and hub are not included with
your printer.
1
Turn off the printer.
2
Turn off the computer.
3
Loop the cable as shown and place the ferrite
core supplied with the printer about 1 inch
(25 mm) from the connector on the printer
end.
13 - English
Publicidad
Capítulos
