Adjust The Image And Focus; Complete The Installation - Axis M32 Serie Guia De Instalacion

AXIS M32 Series

Adjust the image and focus

Open the Live View page in the web interface and make the following
adjustments to the camera:
1. Loosen the locking
screw and tilt adjust-
ment screws.
2. Turn the lens to the
desired position.
3. Once satisfied, gently
tighten the locking
screw and tilt
adjustment screws to
secure the camera's
position.
4. Turn the image
balance ring to set the horizontal position.
5. To set the focus and zoom, loosen the zoom and focus pullers anti-
clockwise and rotate the rings.
6. Lock the focus and zoom pullers in position by rotating the screws
clockwise.
Note:
Due to the dome's refraction, the image may appear slightly out of
focus once the dome has been placed. Focus on an object slightly closer than
the intended area to compensate for this.
The image can also be fine-tuned for low light conditions.
Go to Setup > Video > Camera Settings in the camera's web interface
and see the online help for more information.

Complete the installation

1. Rotate the black protective shield inside the dome casing to match
the camera's position.
2. Clean the dome with a dry soft cloth to remove dust and finger
prints and use a blower to remove dust from the lens.
Image balance ring
Tilt adjustment
screw
(on each side)
Page 11
Locking screw
Zoom puller
Focus puller