Stopping The Machine; Incidents During Sawing; Air Filter - Dimas FS 350/400 C-03 Manual De Explicaciones

• Hold the position of the machine, release the
lever by pressing on the button (H).
• Lower the blade to the desired depth indicated
on the side scale on the ratchet placed on the
side. We recommend a slow descent to avoid
stalling the engine.
• Start moving down to the depth of cut required,
indicated on the gradiated scale fitted on the
side. A slow descent is recommended to prevent
stalling the motor.
• Once the required depth is reached, lock the
lever (by releasing the button) in the appropriate
notch (F).
Ensure that the water supply is abundant,
when cutting wet.
8

Stopping the machine

Motor off.
• Release the lever (by pressing simultaneously on
the button) and pull it towards you to release the
blade from the groove.
• Lock the machine in the high position by means
of the lever (by releasing the button).
• Turn off the water supply.
• Allow the engine to turn at low speed.
• Stop the engine (consult the engine maintenance
manual).
Emergency stop
(engine) :
Operate the switch on the machine's
control panel.
Emergency stop
(electric motor) :
Press the red knob (circuit breaker)
9

Incidents during sawing

• Several causes can result in the blade stopping
in the sawing groove or the machine stopping:
Tension of the belts,
Lack of fuel,
Excessively fast feed or descent, etc.
• In all cases remove the blade from the groove
and check the machine thoroughly.
Entrust repairs to authorised dealer
only
10 Maintenance
(with the engine stopped)
"Engine Maintenance" : refer to the
engine maintenance booklet.
• After use, clean the machine.
• Lubrication: apply a moderate amount of bearing
lubricant to the nipples in the depth adjustment
chassis (depending on the frequency of use).
OIL
• Check ENGINE OIL daily. Read engine owners
manual for O I L and OIL FILTER change
intervals. Use :
SAE 10W30 motor oil with API class MS, SD,
SE or better for PETROL engines.
API class CD or CE for Hatz diesel.
Dispose of the old oil as laid down by
the regulations in force.
• To empty the motor, place a funnel at the drain
.
outlet (V) [ 5].
FIG
X

AIR FILTER

• Read engine owners manual for maintenance
intervals. For extremely dusty conditions you
may have to clean the air filter element 2 to 3
times a day.
• Replace any damaged filters or gaskets.
Store in a safe place out ot reach of
children.
Remove all adjustment tools and
wrenches
Store diamond tool in a safe place so
it cannot be bent or damaged.
23