Maintenance And Repair Instructions - Ryobi ELT 738 Manual De Istrucciones

ELT 738 - ELT 1040

MAINTENANCE AND REPAIR INSTRUCTIONS

INSTALLING A NEW TRIMMING LINE
The trimming line may be replaced by two
methods - rewinding the existing reel or
installing a prewound reel.
Rewinding the Existing Reel
To rewind the existing reel you must:
1. Check for the correct line size.
2. Remove the inner reel and spring.
3. Wind the reel with the new line.
4. Reinstall the existing reel and spring.
The Correct Line to Use
Use a Ø 2,00 mm dual line reel.
Removing the Existing Reel
1. Unscrew the Bump Knob counterclockwise
(Fig. 10).
2. Remove the inner reel (Fig. 11).
3. Use a clean cloth to clean the inside of the
outer spool (Fig.12).
4. Check the indexing teeth on the reel and
spool for wear (Fig.13). If necessary,
replace the reel and spool.
Winding the Existing Reel
1. Insert the ends of new trimming line into
the inner reel holes (Fig.14).
2. Loop the line into two equal lengths before
inserting it into the holes.
3. Wind the line, in even and tight layers
(Fig.15), onto the reel, and in the direction
indicated.
4. Push the ends of the line into the slots (Fig.
16).
6
Reinstalling the Reel
1. Insert the ends of the line through the
eyelets in the outer spool (Fig. 17).
2. Grasp the ends and pull firmly to release
the line from the slots in the spool.
3. Install the Bump Knob clockwise (See Fig.
10).
Line installation is now complete.
Installing a prewound reel
1. Use the same instructions as the existing
reel:
• The Correct Line to Use;
• Removing the Existing Reel;
• Reinstalling the Reel.
CLEANING / STORAGE
1. Do not block the air vents.
2. Do not use strong detergents on the plastic
housing or handle.
3. Moisture can cause a shock hazard. Wipe
off moisture with a soft cloth.
4. Clean the unit thoroughly before storing.
Hang the unit by the handle loop and store
it in a dry, well-ventilated area, out of the
reach of children.