Tabla de contenido
Publicidad
rePlaCinG battery
WarninG
Batteries contain sulfuric acid which may cause burns. Do not short
circuit or mutilate batteries in any way. Do not put batteries in fire as
these may burst or release toxic materials.
1.
Loosen star knobs securing upper and lower handles and carefully
fold the upper handle down toward the lower handle as shown in
Figure 20.
2.
Remove the two screws securing battery cover to battery housing and
place them to the side. See Figure 20.
3.
Open battery cover, remove positive and negative leads from
battery, remove and replace with new battery. Connect the
positive lead to the positive side of the battery pack, then connect
the negative side.
NOTE: The battery you have may differ slightly from the one shown in
Figure 21. Refer to the Parts List.
IMPORTANT: When replacing battery pack in handle panel, battery
pack must be positioned with the positive terminal to the left side
and the negative terminal to the right side of panel (Positive terminal
is closest to the key switch). See Figure 21. Replacing battery pack
incorrectly will cause serious damage.
4.
Reattach battery cover to battery housing by securing with the
two screws removed earlier, making sure to snap the wire conduit
on the left into place on the housing.
5.
Fold handles back up and tighten star knobs.
WarninG
Do not remove the battery pack from the electric starter housing for
any reason other than replacement.
Charging battery
WarninG
The battery contains corrosive fluid and toxic material; handle with
care and keep away from children. Do not puncture, disassemble,
mutilate or incinerate the battery. Explosive gases could be vented
during charging or discharging. Use in a well ventilated area, away
from sources of ignition.
NOTE: The special designed plug on the charger will only fit into the
plug on the battery box.
1.
Plug the battery charger into the port on the underside of the
battery housing. See Figure 22.
2.
Insert the battery charger plug into a standard 120 volt household
outlet. Charge battery for 8 to 10 hours before initial use. Failure
to do so may result in diminished battery life. do not charge
longer than 12 hours. The battery should only need to be
charged upon initial setup and after any other extended periods of
non-use.
3.
After charging, disconnect charger plug from outlet first, then
disconnect charger lead from battery.
SERVICE AND MAINTENANCE
18
Figure 20
Positive
Terminal
Negative
Terminal
Figure 21
1
2
Figure 22
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
