Control Panel Features - Ribind INDUSTRIAL Manual De Instrucciones

POINT A -

CONTROL PANEL FEATURES

T1
T2
JC
JB
JA
POWER
400 VAC
+
NEUTRAL
COM Common contact
J2
LSC Closing limit switch contact (NC)
LSO Opening limit switch contact (NC)
LSSC Not used
LSSO Not used
TLC Vehicle presence signal (NO) (only when switched to PARK mode)
Photocells contact (NC)
PHOT. NC Safety strip contact (NC)
EDGE NC Common contact
COM Safety strip self-test power supply +12Vdc 500mA
D+ TEST max
Accessories power supply +12Vdc 500mA max
D+ Accessories power supply -12Vdc 500mA max
D-
Barrier opening button 2 contact (NO) (only when
OPEN 2 switched to PARK mode)
J3
SIGNAL Barrier open signal 12Vdc
Buzzer - Acoustic signal connection (12Vdc max 200 mA)
Radio antenna
AERIAL
Blinker (max 40W)
J4
Immediate closure command contact (only when switched
J5 OK CLOSE to PARK mode)
Open 1 button contact (NO)
OPEN 1 Close button contact (NO)
CLOSE Stop button contact (NC)
STOP Single pulse button (NO)
K BUTT. Common contact (common line for all the commands and
COM safety inputs)
PROBE Not available
J6
MOTOR
J7
J8
J9
J10
S3
T1 - T2
JA
JB
JC
29
29
J4
S3
J9
J5
J2 J3
RADIO Built in radio module
AUX. ATT. Card 1 relay connector (code ACQ9080) for management
of courtesy light
Card 3 relay connector (code ACQ9081) for management
of courtesy light and traffic lights
SW PARK DO NOT TOUCH THE JUMPER!
IF REMOVED THE OPERATOR DOES NOT FUNCTION!
SW RADIO Not used
PROG. Programming button
CARD R2
Power relays for the command of the motor
R-S-T Three-phase power supply
N Neutral
Contacts for the earth conection
U-V-W Motor connection
L1-N Single phase power supply for the S1 control panel to be
done by the manufacturer
X-Y-Z Connection to the power relays, to be done by
the manufacturer
G
B
J8
J7
J6
J10