The term "electromagnetic compatibility" is intended as the abili-
ty of the product to function smoothly in an environment in which
electromagnetic radiation and electrostatic discharge are pre-
sent and without causing electromagnetic interference to other
equipment.
WARNING:
The product complies with the most stringent requirements
of the relevant standards and regulations. However, the pos-
sibility to cause interference in other devices cannot be to-
tally excluded.
The device produces a visible laser beam which emer-
ges from the front of the instrument.
It is a Class 2 laser product in accordance with:
••
IEC60825-1: 2007 "Radiation safety of laser products" -
Class 2 Laser products.
2.Start-up
Built-in rechargeable lithium battery
The battery must be fully charged before you start working. When
the display shows
, please charge it in time.
Setting of the unit of measurement
Long press
(FUNC/UNIT) once to change unit of measure.
The following units are available: m, in, ft.
Reference point from which the measure is taken
By default, the rear of the instrument is the reference point where
the measurement is taken from. The display shows
Long press the button
the upper edge, the display will show
will be carried out starting from the upper edge.
3. Power on/off
By pressing the button (
light up. The display shows the battery symbol.
By pressing the button
switches off.
The tool also automatically turns off after 3 minutes of inactivity.
Clear button
(CLR/OFF) the last action is cancelled.
By pressing the button
While taking measurements of area or volume, each individual
measurement can be deleted and re-measured in series.
4.Measurement
Single distance measuring
Turning on the laser indicator, briefly pressing the button
measurement will take place after a second press of the same
button.
The measurement results will be immediately displayed on the
screen.
.
(+/-) to move the reference point on
and the measurement
x 2) , the instrument and the laser
(CLR/OFF) longer, the instrument
the
11