Rollei Studioblitz 400 Manual Del Usuario página 19

Wireless control
Infrared Slave Mode
Press the Set button (12) and the wireless control button (13) at the
same time for 2 seconds to enable or disable the photo cell function .
The function is active, the relevant symbol is shown on the display .
The flash can then fire a burst as soon as another flash emits a light
pulse . The infrared sensor must not be obscured for that .
Channel
Press the SET button (12) once and change the channel number with
the (+) and (–) button . This number can be selected from 00 up to 15 .
Please note: The values can only be changed if the message blinked
on the display .
Group
Press the SET button (12) twice and change the group with the (+)
and (–) button .
Here you can select between the groups A / B / C/ D / E / F / H / I and J .
Please note: The values can only be changed if the message blinked
on the display .
Mask pattern
Press the mask pattern button (12) and select
the group numbers with the (+) and (–) button .
• The group can be set between 1 and 2 .
• The flash in group 1 will be the first to be released .
• The flash in group 2 will fire only during the second release .
You will find further information about mask pattern mode in the
section entitled Mask Pattern .
19