Symbols Used In This Manual; Symbols On The Power Tool; Technical Specifications - Flex CHE 2-28 SDS-plus Instrucciones De Funcionamiento Originales

Contents
Symbols used in this manual . . . . . . . . . 12
Technical specifications . . . . . . . . . . . . 12
Overview . . . . . . . . . . . . . . . . . . . . . . . . 13
For your safety . . . . . . . . . . . . . . . . . . . 14
Noise and vibration . . . . . . . . . . . . . . . . 15
Instructions for use . . . . . . . . . . . . . . . . 16
Maintenance and care . . . . . . . . . . . . . . 19
Disposal information . . . . . . . . . . . . . . . 20
-Declaration of Conformity . . . . . . . . 20
Exemption from liability . . . . . . . . . . . . . 20

Symbols used in this manual

WARNING!
Denotes impending danger.
Non-observance of this warning may result
in death or extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation.
Non-observance of this warning may result
in slight injury or damage to property.
NOTE!
Denotes application tips and important
information.

Symbols on the power tool

Before switching on the power
tool, read the operating manual!
Wear goggles!
Wear ear protection!
Use light-weight breathing
protection!
Disposal information for the old
machine (see page Disposal
information)!
12

Technical specifications

Hammer drill and chisel
hammer
Rated power
No-load speed
No-load impact rate
Max. single impact energy
(according to "EPTA-
procedure 05/2009")
Lubrication
Tool holder
Max. drill diameter
- Concrete
- Masonry
(HM drill bit)
- Wood
- Metal
Weight according
to "EPTA Procedure
01/2003"
CHE 2-28
CHE 2-28
SDS-plus
W 800
min 0-1300
-1
min 0-4000
-1
J 2.7
Grease
SDS-plus
mm 28
mm 68
mm 30
mm 13
kg 2.65