maintaining your washer
CLEANING THE DEBRIS FILTER
We recommend cleaning the debris filter when water does not drain well or the "ND" error message is
displayed.
1. Open the filter cover by pressing and pulling the handle of the
filter cover with your finger.
2. Unscrew the drain cap by turning it
counterclockwise.
3. Hold the cap on the end of the drain tube and
slowly pull it out about 6 inches (15 cm) and
drain off all the water.
4. Remove the debris filter cap.
5. Wash any dirt or other material from the debris filter. Make sure
the drain pump propeller behind the debris filter is not blocked.
6. Replace the debris filter cap.
7. Replace the filter cover.
PRESERVING THE TOP COVER AND THE FRONT FRAME
Do not place heavy objects on the washing machine.
This may scratch or damage the top cover of the washing machine.
Since the entire washing machine has a high-gloss finish, the surface can be scratched or damaged.
Therefore, avoid scratching or damaging the surface when using the washing machine.
Do not place any heavy or sharp objects or a detergent box on the washing machine. Keep them on the
purchased pedestal or in a separate storage box.
22_ maintaining your washer
WF448AAW-02535A-02_EN.indd 22
Step 1
Step 2
2008-05-06 ¿ÀÈÄ 2:23:29