Electrical Requirements - Craftsman 139.53915 Manual Del Propietário

Abridor de puerta de cochera con conectivo assurelink
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION STEP 13

Electrical Requirements

To avoid installation difficulties, do not run the opener at
this time.
To reduce the risk of electric shock, your garage door opener has
a grounding type plug with a third grounding pin. This plug will
only fit into a grounding type outlet. If the plug doesn't fit into the
outlet you have, contact a qualified electrician to install the proper
outlet.
RIGHT
If permanent wiring is required by your local code, refer to
the following procedure.
To make a permanent connection through the 7/8 inch hole in the
top of the motor unit:
1. Remove the motor unit cover screws and set the cover aside.
2. Remove the attached 3-prong cord.
3. Connect the black (line) wire to the screw on the brass
terminal; the white (neutral) wire to the screw on the silver
terminal; and the ground wire to the green ground screw. The
opener must be grounded.
4. Reinstall the cover.
WRONG
To prevent possible SERIOUS INJURY or DEATH from
electrocution or fire:
Be sure power is NOT connected to the opener, and
l
disconnect power to circuit BEFORE removing cover to
establish permanent wiring connection.
Garage door installation and wiring MUST be in compliance
l
with ALL local electrical and building codes.
NEVER use an extension cord, 2-wire adapter, or change plug
l
in ANY way to make it fit outlet. Be sure the opener is
grounded.
PERMANENT WIRING
CONNECTION
Ground Tab
Green
Ground Screw
Ground Wire
26
Black
Wire
Black Wire
White Wire

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido