Alcad 912-TQ Guía Rápida De Programación página 3

QUICK PROGRAMMING GUIDE 912-TQ DVB-S/S2 TO DVB-C
Start/on
Main menu
Select series Transcodifi cador 912 QPSK - COFDM
NIT Table
Select series
912-TQ Transmodulator DVB-S/S2 to DVB-C
912-MS Modulators
912-TQ Transmodulator DVB-S/S2 to DVB-C
Confi gure module
Set the programming switch of the 912-TQ module to the ON position. The programming
Input
Power LNB
off
off off
on
Input frequency
1952
Symbol rate
Auto
Standard
DVB-S2
Modulation
QPSK
Roll off
0.35
FEC
Auto
Input level
BER
indicator will now light up and remain lit.
OK+
MHz
Keypad + T
1000 KBd Keypad + T
OK+
OK+
OK+
OK+
65 dBuV
< 1E-7
Press the Power On key of the PS-011 to start up the
system.
Choose Select Series to select the programming series.
OK
Select the series: 912-TT Transmodulator DVB-S/S2 to
OK
DVB-C.
To commence programming the module, select Confi gure
OK
module.
Select LNB power on/off. Then press T to transmit.
Using the numeric keypad, enter the FI frequency of the
+OK+T
transponder. Then press T to transmit.
Enter the input frequency of the transponder using
the numeric keypad. Then press T to transmit.
Enter the symbol rate of the transponder using the
numeric keypad. Then press T to transmit.
Select the standard DVB-S/DVB-S2. By default it is
+OK+T
set to Auto. Then press T to transmit.
Select the modulation QPSK/8PSK. By default it is set
+OK+T
to Auto. Then press T to transmit.
Select the roll off. Then press T to transmit.
+OK+T
Select the forward error correction rate (FEC) of the
+OK+T transponder. By default it is set to Auto. Then press T to
transmit.
When the input transponder data have been entered,
press the READ key to obtain a reading of the input
READ
signal.
ENG