Printing Language Change Mode - Terragene Bionova IC10/20FR Manual Del Operador

Features, care, cleaning and maintenance
To increase unit minutes value, press
decrease unit minutes value, press
gure 5).
Finish hours setting
To save changes press and hold
Figure 4) for three seconds. A beep will sound, PRO
green light will turn on and a ticket with the new set
time will be printed to indicate the procedure has
been completed successfully.
NOTE: If the modification has not been done correct-
ly, the incubator will emit 3 beeps and the red light
from PRO sector will turn on. Repeat the procedure.
Cancel hours setting
To cancel hours setting procedure without saving the
changes, disconnect power source.

Printing language change mode

This function allows you to change the incubator
printing language.
NOTE: each language has a code number assigned:
1 English
2
Spanish
3
Portuguese
4
Turkish
Enter to Printing language change mode
De-energize the incubator.
Press and hold
ment. A sound will be emitted to indicate Access to
Printing language change mode.
button. To
button. (See Fi-
button (see
Use
ber corresponding to language code.
Finish printing language change
To save changes press and hold
three seconds. A sound will be emitted indicating
that process has been completed successfully. A tic-
ket with the new language will be printed.
IC10/20FR Page 16
button and energize the equip-
and buttons to select the position num-
button for