Before Use - Omega Lift Equipment 44010 Manual De Piezas E Instrucciones De Funcionamiento

BEFORE USE

1. Verify that the product and the application are compatible, if in doubt call Omega technical service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the potential hazards associated with its use.
3. To familiarize yourself with basic operation, turn the release valve lever:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the ram plunger.
b. Counter-clockwise, but no more than 2 turns from the closed position. This is the 'OPEN' release valve position
used to lower the ram plunger.
!
WARNING: Clear all tools and personnel before lowering load. Open
release valve slowly. The further handle is turned counter-clockwise, the
faster the load will descend. Maintain control of the load at all times.
4. Remove hydraulic unit and position as shown in figure 5.
5. With ram plunger fully retracted, remove the oil filler plug. Insert the handle
into the handle sleeve, then pump 6 to 8 strokes. This will help release any
pressurized air, which may be trapped within the reservoir. Ensure the oil
level is just below the oil filler hole. Reinstall the oil filler plug.
6. Reinstall hydraulic unit.
7. Check to ensure that crane rolls freely and that the pump and release valve
operate smoothly. Raise and lower the unloaded crane throughout the lifting
range before putting into service. Replace worn or damaged parts and
assemblies with Factory Authorized Replacement Parts only.
OPERATION
!
WARNING: Use of this engine crane is limited to lifting, lowering, and transporting in the lowest possible
position, automotive and light truck engines. It is NOT and should never be used as a work station.
For model 44020:
The crane features length adjustable boom and length and width adjustable leg extensions. Extend both rear legs
to an equal width. It is recommended that both rear legs be extended to the maximum allowable distance as limited
by the marking on each leg. Both front leg extensions must be positioned to match the rated capacity markings on
the booms. Both rear and front legs must be secured by means of a locking fastener found on each leg frame tube.
Do not overtighten.
!
WARNING: Front legs must be extended to equal length and match the
rated capacity markings found on the boom. Never operate crane with boom
and leg extensions positioned at different capacities (ref. Figure 6.)
For All Models:
Always refer to vehicle service manual and/or shop manual for location of
appropriate engine lift points and removal procedures. Each engine removal/
installation may required different tools, procedures, and level of expertise.
!
WARNING: Lift only on areas of the engine as specified by the vehicle
manufacturer.
!
WARNING: Never load the crane with an engine that extends beyond
an imaginary line drawn connecting the centerlines of the front and rear
wheel/caster axles as shown in Figure 6.
6
Plunger
Oil Filler
Plug
Release
Valve Lever
Figure 5 - Hydraulic Unit/ Ram
Figure 6
Ram
Handle
Sleeve
Handle